Let the concrete set and do not touch the pillars for two or three days.Īfter the concrete congeals, you can start making top and bottom rails. Now you can add the concrete to the holes fill them completely. Set the post into the apertures and check the vertical and horizontal level. If needed, saw the pillars to shorten them. Put some gravel for drainage at the bottom of each hole to prevent the posts from rotting. You have to dig at least 2 feet down to fasten the fence pillars securely. Use the post hole digger to make the apertures into the ground. You may add some extra posts if needed, but still you have to avoid using too many of them. In average, the distance between two pillars has to be from 7 to 10 feet. You should be made aware with the instructions on how to build a welded wire fence or barbed one before you start working.Īs a first step, you have to map out a plan of posts locations and then measure where the posts have to be placed on your land parcel. concrete – premixed dry mortar or the components you’ll mix by yourself (it’s better not to prepare the concrete until you dig all the post holes), gravel for the post holes.ĭetailed Instructions on Building a Wire Fence.tape measure, level, any other metering equipment you may need.deck screws, L-brackets, fence rolls, gate latches, and hinges.circular saw in case that you need to shorten the posts.wire (welded or barbed, of your choice).If you are found to have caused an obstruction, you will be expected to remedy the situation, and this can be extremely costly as it may involve moving the entire fence.Items, Tools, and Equipment You Need to Build a Wire Fenceīefore you having a dig at building your wire fence, prepare all the necessary things listed below: If you encroach on these public rights of way with your fencing, the courts have made it clear that this will be seen as an obstruction, and this can be viewed as a criminal offence. If the width of the path isn’t stated, make sure you investigate further and ask for assistance from the authority’s rights of way officer to clarify the issue. Often, they are willing to send these documents to you but, if not, they will be available for public inspection at the county hall. The position of these footpaths is recorded on the definitive map and the width of the route may be recorded on a definitive statement, these are usually held by the County Council or Unitary Authority. It’s not just as simple as setting out fencing around recognised footpaths and you must check not only the exact route of the footpath, but also its width. Landowners must always seriously consider barbed wire and all types of fencing where public footpaths and livestock are involved. It’s worth noting that while barbed wire may seem a minor issue, there are potential criminal penalties for those who are found to be liable for injuries or for obstructing public rights of way. In this blog, I thought we’d cover some of the basics and help landowners to understand barbed wire regulations, showing what you can and can’t do and some of the key considerations when planning how to use fencing when it is close to a public right of way. Landowners argue that barbed wire plays an important role in keeping cattle in and in protecting the public from straying into dangerous areas – It is clear though that barbed wire can be a hazard for people using public rights of way. One frequently asked question is “how close can you put barbed wire to a public right of way?”.īarbed wire can cause issues between rights of way users and landowners and has been the subject of a wide range of disputes. For landowners, understanding the rules relating to barbed wire in England and Wales is important.
0 Comments
Leave a Reply. |